Lessons Learned from Launch of New ES&H Orientation Training
7876 Views
Feedback
0 Comments

Favorite
Image for Lessons Learned from Launch of New ES&H Orientation Training

Type:  Lessons Learned

Publisher:  SLAC National Accelerator Laboratory, Menlo Park, CA

Published As:  Public

Date: 

Topics:  Safeguards and Security, Operations, Work Management/Planning

On November 3, 2016 at 11:30 a.m., SLAC deployed a software update for SLAC security gate access badge readers. The software update reflected recent changes in SLACs general ES&H orientation training. Shortly after the deployment, employees, users, and contractors found that their SLAC badges no longer worked in the sites gate access badge-readers. Upon discovery of the problem, SLAC security personnel were deployed around the site to assist personnel with gate access. The cause of the problem was promptly identified and corrected with normal badge reader access resumed by 1:20 p.m.

You must be logged in to open the attachment.

Download Article
Did you find this article helpful?

Favorite
Comments about this Article
You must be logged in to add or view comments.
Related Articles

Negative Performance Trend with the Accuracy and Completeness of Documents and Records

American Recovery and Reinvestment Act (ARRA) Lessons Learned

Assure Foreign Nationals are Approved for Subcontract Work

Water Tank Fill Hose Loss of Control

Hurrying Is An At-Risk Behavior That Can Lead to Undesired Consequences

M-43 Diesel Generator Trip Due To Loss Of Fuel Oil

Best Practices in Project Management: Successful ten-month project planning required for a two-week steam-supply plant shutdown to carryout inspections and critical equipment repair.

Improper Conduct of OJT Results in a Loss of Supply to N-16 System

Employee Injured While Operating a Horizontal Bandsaw

Confirmation Bias - Influencing Error Detection

Near Miss: Unexpected Positive Pressure in Drum During Lid Removal

Hose Not Mechanically Secured during Blow-Down Strikes Worker

Rocks Thrown From the Tires of Rolling Stock

Electrician Inadvertently Trips Breaker while Explaining Racking Procedure during Walkdown

Differing Levels of Worker Experience and Handling Highly Contaminated Materials

Employee Received a Corneal Abrasion While Wearing Safety Glasses with Side Shield

Failure to Implement Compensatory Measures Allows for Recurring Issues

Maintain Control of Work: Programmatic and Human Performance Weaknesses Contribute to Clothing Contamination

Revisit Hazards, Controls Associated with Active Vehicle Barriers

Employee Falls Into Cooling Tower Basin when Basin Grating Support Fails

Work Order Acceptance Criteria

Peer to Peer Accountability - Valve Turning

Operator Fractured Cheekbone Performing Routine Operational Check

Consider Degraded Equipment from Fire Events during Pre-Planning Hazard Analysis

Moving HVAC Parts Pose Amputation Risk

Acid Spill from Floor Cleaning Machine

Arm Injury from Fall on Walk Board

Radiological Containment - Sleeving In and Sleeving Out

Communicate Facility and System Changes to Prevent Accidents

Employee Injured Moving Manhole Cover during Pre-job Walk-down

Personnel Performing Work In An Electrical Control Panel Without Proper Hazard Mitigation

Corrective Actions implemented in response to contamination control event may have produced unintended consequences.

Control Air Compressor Failure Leads to Loss of Ventilation

Improper Rigging Practices Result in Potential Shock Loading of Crane

Assumptions Lead to Less Than Adequate Hazard Identification and Implementation of Controls

Positive Verification during Critical Component Modification is Essential

Take a Cautious Approach when Making Wall Penetrations

DOE Operating Experience Level 3 - Danger! Equipment Hits Overhead Lines

Generator Circuit Breaker Explosion at Priest Rapids Dam

Near Miss - Beam Clamp Hanger and Threaded Rod Falls from Ceiling

Feedback Form
How did you apply this information?
You must be logged in to use this feature
Is this article applicable to your organization?