Improper Rigging Practices Result in Potential Shock Loading of Crane
7996 Views
Feedback
2 Comments

Favorite
Image for Improper Rigging Practices Result in Potential Shock Loading of Crane

Type:  Lessons Learned

Publisher:  Washington River Protection Solutions, Hanford Site (WRPS)

Published As:  Public

Date: 

Topics:  Occupational Safety and Health, Engineering, Operations, Maintenance, Construction/Project Management, Property Management, Training and Qualification, Work Management/Planning, Hoisting and Rigging, Deactivation and Decommissioning

The configuration, weight, and underground interferences associated with objects, such as concrete foundations, must be known before attempting to lift them with a crane. Cranes are designed for lifting and moving loads only. Pulling imbedded objects or stuck objects is an improper use of a crane. Inadequate rigging choices and poor decision making could have resulted in personnel injuries, dropping the load, and shock loading the crane.

You must be logged in to open the attachment.

Download Article
Did you find this article helpful?

Favorite
Comments about this Article
You must be logged in to add or view comments.
Related Articles

Assumptions Lead to Less Than Adequate Hazard Identification and Implementation of Controls

Preventive and Corrective Maintenance Programs Are Imperative to Keeping Structures in a Safe Condition

American Recovery and Reinvestment Act (ARRA) Lessons Learned

Staying Focused During Transition

Hose Not Mechanically Secured during Blow-Down Strikes Worker

What Safe Practices Will You Do Today To Get To Tomorrow?

Unanticipated Energy Source Found in Lock-and-Tag Boundary

Cooperation between Multiple Organizations and Companies Key to Achieving Fire Service Water Tank Recoating Project Success

Dangers of Objects Falling into Normally Occupied Areas

DOE Operating Experience Summary 2014-04

DOE Operating Experience Summary 2014-02

SAFETY ALERT - Scaffold Pole Failure

Specify Roles and Responsibilities

Large Roll-up Door Drops due to Poor Installation/Inspection

Moving HVAC Parts Pose Amputation Risk

New equipment configuration and work practice changes enable significant improvements in safety and efficiency

Arm Injury from Fall on Walk Board

Laborer Crushed during Demolition of Steel Structure

Employee Injured Moving Manhole Cover during Pre-job Walk-down

Positive Verification during Critical Component Modification is Essential

Forklift Rigging Assembly Fails during Lifting Attempt

Generator Circuit Breaker Explosion at Priest Rapids Dam

Worker Fatality During Attempted Removal of Blind Flange on Magnet Cooling Water System

Work Package for Subcontractor Elevator Repair Raises Questions on Hazard Controls

Wrong Tool (Aerial Lift) Used for the Job

Roofing Material Blown Off Roof Lands Near Pedestrian Sidewalk

Rocky Flats Closure Legacy

Inadequate Communication Results in Crane Boom Sheave Damage

Less than Adequate Configuration Control of Boiler Drain

Lessons From a Successful Underground Explosive Fracturing Project

DOE Operating Experience Level 3 - Safety Concern: Roll-up Doors

Avoid Hazards and Injury with Consistent Procedures and Verification

DOE Operating Experience Summary 2014-03

Severe Accident at ORNL Excess Property Sales

OSHA FATALFacts - Fall from a Telecommunications Tower

Electrical Conduit Cut During Aggressive Concrete / Masonry Penetration

MSHA - Fatal Electrical Accident November 18, 2013

Work Being Performed in a Confined Space May Create Hazards that Create Permit-Required Confined Space Conditions

Safety and Health Standard Requirements May Not Fully Address ISMS Principle for Hazard Control

Hidden hazards associated with wall/floor/ceiling penetrations

Feedback Form
How did you apply this information?
You must be logged in to use this feature
Is this article applicable to your organization?